CUMMINS GSBB Installationshandbuch

Operator and Installation ManualEnergy Command 30English 12-2007 900−0541 (Issue 3)(Cummins PN 018-01049 Rev 1.6c)

Page 8 SYSTEM INFO Display The SYSTEM INFO display allows access to key information. Pressing ENTER once will display the reason for the last auto

Page 9 • Brake: Brake light for all trailer, 5th wheel, and pickup camper installations, or air brake on diesel motor homes. • Park: The park si

Page 10 Effect of Increasing START @ V OR Time @ START V Effect of Increasing # Starts Runtime Battery Level START @ V More Less Higher Time

Page 11 Installing the Energy Command 30 Overview This section describes how to install the Energy Command 30 (EC-30). General This system is on

Page 12 OEM Supplied Equipment Required for Installation Manufacturer & PN Mating Connector Housing Tyco/AMP 770583-1 Pins (Up 16 required

Page 13 Wiring Installation 1. Use wire tags or labels to label each end of every wire. Use Figures 5 and 6 to determine the correct labels and c

Page 14 WIRE #9 Engine Battery Sense 12-24VDC: This wire supplies the positive sense voltage for the engine starting battery. This is an optional

Page 15 This input should be treated like a relay coil input, or a light bulb. It must be supplied with both a positive and a negative. The actua

Page 16 Troubleshooting If controller functions do not operate properly, proceed as follows;. 1. Does the genset operate correctly from the g

Page 17 Appendix A Onan Gensets for Use With the EC-20/30 QUIET DIESELS MODEL KW PRODUCT EC-20/30 GEN TYPEService IN HoursConnection Figure Onan

Page 18

Page 19

Page 20

Page 21

Page 22

Page 23

Page 24

Page 25The mounting footprint for the control is shown be-low. Select an appropriate mounting location,make sure there is enough room to install the c

Page 26

Cummins Power Generation1400 73rd Ave. NEMinneapolis, MN 55432 USAPhone 1 763 574 5000Toll-free 1 800 888 6626Fax 1 763 574 5298Email www.cumminsonan

Page 1 Operation and Installation Manual PN 018-01049 Rev 1.6c Energy Command 30 General The Energy Command 30 (EC-30) is an Automati

Page 2 OPERATION PANEL QUICK REFERENCE UP/DOWN: This key is used to scroll through display choices and change values that can be SET.ENTER: T

Page 3 Operation of the Energy Command 30 Overview This section describes how to use the Energy Command 30 (EC-30). The Quick Start page defines k

Page 4 When the safety input signal changes from off to on (or on to off), EC-30 stops the genset and changes the genset operating Mode to MANUAL.

Page 5 Adaptive Cycle Management The automatic modes have unique features to minimize repeatedly starting and stopping the genset, also called sho

Page 6 The SERVICE DUE message is displayed as soon as the service interval has elapsed. The UP/DOWN key still allows navigation through the main

Page 7 Setting Up and Testing the Energy Command 30 Overview This section describes how to Setup and Test the EC-30. Before using the EC-30 for