CUMMINS ED-3 Betriebsanweisung PDF herunterladen (Seite 7)

Initial Setup

On initial power up the display will automatically enter screens within the Settings and

Conﬁg Menus which need to be set up by the user in order to use the display. Once these

are set on the initial power-up, it is not necessary to repeat these steps. If the initial settings

have been set incorrectly, the setup screens can be corrected via the Conﬁguration Menu

(see Conﬁguration Menu section).

The user is ﬁrst prompted to select the engine

model to which the display is connected.

Use up/down scroll keys (Key 1 or Key 2)

to move the pointer to the desired engine

model. Press the SELECT key (Key 4) to

ﬁll in the box in the right hand column

adjacent to the desired model, then press

the BACK key (Key 5).

Setting Menu

Allows changing the following:

LANGUAGE Conﬁgurable

BLEEP ON/OFF

UNITS ENGLISH/METRIC

DAMPING 0-100% (How fast the data is updated on the screen)

ALARM ON/OFF (Basic Page will show to indicate alarm is off.)

Caution: Turning the alarm off will prevent the display from showing any

active faults. Use this function only when the Engine Data Display is not

used at the helm.

SPEED GPS ON/OFF

Boat speed value can be received from either a GPS (speed over ground)

or a speed transducer (speed over water). This feature is for the Marine

application only. See the appendix for required wiring connections.

Alarm History

Provides engine snapshot data that was captured with the 5 most recent engine fault codes.

These fault codes cannot be cleared by the user.

Key 1 Key 2 Key 3 Key 4 Key 5

Use the up/down scroll keys (keys 1 and 2)

to move the pointer to the data type item

followed by the ADJ key (key 4) to select

between J1939 and J1587 Data type.

The display then enters the Data-link

screen and the user should select Data

type, either J1587 or J1939.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

CUMMINS ED-3 Betriebsanweisung Seite 7