CUMMINS QC5200 Betriebsanweisung PDF herunterladen (Seite 63)

Subsystem List

This pop-up contains subsystems with parameters that may

be broadcast

. In order to change the subsystem source of a

parameter, tap the Subsystem pop-up list, select the desired

subsystem, and save any changes you have made to update

the QuickCheck CE databases with the new configuration.

The application will read from the selected subsystems for

each parameter configured on either datalink. Note that the

combination of the faults subsystem and parameter

subsystems you can configure with the QC Configurator

program is limited to a maximum of 3. If you select more

subsystems than that for a configuration, you must remove

one or more subsystems from your configuration; otherwise,

QuickCheck CE will not properly read some of the messages

you have just tried to configure it to read.

A parameter may not be broadcast from every subsystem listed. Even

the more common engine or vehicle subsystem parameters may be

supported on some subsystem makes and models, but not on others.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 88 89

Keine Kommentare

CUMMINS QC5200 Betriebsanweisung Seite 63