CUMMINS N14 Spezifikationen PDF herunterladen (Seite 276)

100

101

Caution: Support the cylinder head to prevent damage

to the injector tip that protrudes from the combustion

face.

Apply a very light film of blueing compound to the outside

diameter of the injector at the injector seat area. Blueing

compound can effectively be applied with your finger or

with a brush.

Install the injector in the cylinder head without o-rings.

Place a 1.2-inch thick block under the injector hold down

clamp. This represents the rocker housing.

Tighten the injector hold down capscrews.

Torque Value: 54 N•m [40 ft-lb] STC and CELECT™

Turn the cylinder head over and use a depth gauge, Part

No. 3823495, to measure the injector tip protrusion.

Injector Tip Protrusion

mm in

1.47 MIN 0.058

1.82 MAX 0.072

NOTE: If the injector tip protrusion does not meet the spec-

ifications given, the injector sleeve must be machined again.

Remove the injectors from the cylinder head, and check

the pattern of the blueing compound in the injector sleeve.

Cylinder Head - Replacing the Injector Sleeves (02-07) Cylinder Head

N14Page 2-34

1 2 ... 271 272 273 274 275 276 277 278 279 280 281 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 276

Kommentare zu diesen Handbüchern