CUMMINS N14 Spezifikationen PDF herunterladen (Seite 44)

100

101

STC External Oil Plumbing - Removal

Disconnect the external oil manifold supply line from the

rear of the external oil manifold.

Plug the supply line to avoid dirt contamination.

Caution: Hold the oil manifold fitting hex with a backup

wrench while removing the supply line to avoid damag-

ing the manifold.

Remove the three external oil manifold hold down cap-

screws.

Remove the three mounting clips, capscrews, and spac-

ers.

Remove the external oil manifold from the connector.

Remove the two oil manifold connector mounting cap-

screws.

Remove the oil manifold connector from the rocker lever

housing.

NOTE: Use a wide, flat pry bar to pry at the center of the oil

manifold connector. Remove the connector evenly from both

pass through ports simultaneously to prevent damage to the

connector or the rocker lever housing.

NOTE: If necessary, remove the intake air tube and elbow

from the intake prior to removing the oil manifold connector.

Repeat this procedure for each rocker housing.

Remove the following hoses from the STC oil control

valve and the engine:

1. Fuel Rail Pressure Signal Hose

2. Oil Supply Hose to Tappets

3. Crankcase Vent Hose

4. Oil Supply Hose from Oil Rifle

STC External Oil Plumbing - Removal Engine Disassembly (00-01)

N14Page 0-24

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 44

Kommentare zu diesen Handbüchern