CUMMINS N14 Spezifikationen PDF herunterladen (Seite 55)

100

101

Valve Crossheads - Removal

Remove the crossheads. Be sure to mark them appro-

priately so they can be installed in the same location and

orientation during the installation procedure.

NOTE: Excessive crosshead wear can result if the cross-

heads are not installed in their original locations. The larger

hole on the underside of the crosshead must be oriented

toward the exhaust side of the engine.

Push Tubes - Removal

Remove the push tubes.

NOTE: To prevent increased wear, mark each push tube as

it is removed so it can be installed back in itsoriginal location.

Injectors - Removal

CELECT™ Engines

Disconnect the injector solenoid leads from the pass

through connector in the rocker housing.

Remove the injector hold down clamp capscrew.

Remove the injector and the hold down clamp.

Use injector puller, Part No. 3823579, to remove

CELECT™ injectors. Insert the pin of the tool into the hole

provided in the body of the injector. The hole faces the

exhaust side of the engine.

Caution: Do not catch the injector puller into the top

stop spring cage. Damage to the injector will occur.

Engine Disassembly (00-01) Valve Crossheads - Removal

N14 Page 0-35

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 55

Kommentare zu diesen Handbüchern