CUMMINS N14 Spezifikationen PDF herunterladen (Seite 73)

100

101

The end of the lower main bearing shell opposite the

dowel ring must be engaged between the crankshaft and

the cylinder block and be seated against the end of the

upper bearing shell.

NOTE: If installed correctly, the ends of the bearing shells

(1) will meet approximately 1.50 mm [0.060-inch] below the

cylinder block main bearing mounting surface.

NOTE: If used thrust bearings are to be installed, each must

be installed in its original location in the engine. The bearing

journal numbers must have been marked on the bearing

during disassembly.

Use clean LubriplateT 105 or its equivalent to lubricate

the lower thrust bearings.

Put the lower thrust bearings around the No. 7 main

journal with the grooves facing the thrust surfaces on the

crankshaft.

NOTE: The notch (1) on the outside diameter of the lower

thrust bearings must align with the locating pins in the No.

7 main bearing cap.

Use clean 15W-40 oil to lubricate the capscrew threads

and the flat washers.

Caution: Drain the excess oil from the capscrews before

installing them in the cylinder block to prevent hydraulic

lock and possible damage to the cylinder block during

the capscrew torquing operation.

Engine Assembly (00-02) Crankshaft - Installation

N14 Page 0-53

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 73

Kommentare zu diesen Handbüchern