
Rocker Housing Covers - Removal
Remove the ten capscrews from each rocker lever cover.
Remove the rocker lever covers. The rocker housing
cover gaskets can be used again if they are not dam-
aged.
Caution: Do not clean reusable gaskets with any solvent
or steam. Solvent and steam will damage the gasket
material. Clean only with soap and water.
Engine Brakes - Removal
Disconnect the C-Brake harness wire from the electrical
connector on each C-Brake housing.
Remove the capscrews from each C-Brake housing.
Remove the C-Brake housing.
Remove the C-Brake housing gasket.
Rocker Lever Shaft Assemblies -
Removal
Loosen the valve and injector adjusting screw lock nuts
on each rocker lever.
Turn the adjusting screws counterclockwise until the
rocker levers are loose.
Caution: Do not attempt to remove or install the rocker
lever shaft assemblies without first loosening the levers.
Remove the rocker lever shaft capscrews and the rocker
lever shaft assemblies.
NOTE: To prevent increased wear, mark each rocker lever
as it is removed so it can be installed back in its original
location.
NOTE: Hold the shaft at both ends so that the rocker levers
do not slide off.
Rocker Housing Covers - Removal Engine Disassembly (00-01)
N14Page 0-34
Perfect..