CUMMINS N14 Spezifikationen PDF herunterladen (Seite 76)

100

101

Measure the end clearance of the crankshaft.

Install a dial indicator to the rear face of the cylinder block.

Put the tip of the gauge against the end of the crankshaft.

Push the crankshaft toward the rear of the cylinder block.

Set the dial indicator to ‘‘0.’’ Push the crankshaft toward

the front of the cylinder block. If the end clearance is less

than 0.10 mm [0.004-inch], do the following:

Loosen the main bearing capscrews one turn.

Push the crankshaft toward the front and then toward the

rear of the cylinder block.

Tighten the main bearing capscrews in the sequence

shown to the torque values listed previously in this

procedure.

Crankshaft - Installation Engine Assembly (00-02)

N14Page 0-56

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 76

Kommentare zu diesen Handbüchern