CUMMINS N14 Spezifikationen PDF herunterladen (Seite 86)

100

101

Remove the pins from the crankshaft oil seal driver, Part

No. ST-997; and use the driver to align the rear cover with

the crankshaft.

Install the seal drive in the crankshaft flange and in the

bore of the rear cover.

Tighten the rear cover mounting capscrews.

Torque Value: 47 N•m [35 ft-lb]

Remove the crankshaft oil seal driver, Part No. ST-997.

Use a gauge block, Part No. 3823495, to make sure the

rear cover is within 0.10 mm [0.004-inch] of being parallel

with the oil pan flange of the cylinder block.

Trim the excess gasket material from the ends of the rear

cover gasket so the gasket is even or does not extend

more than 0.25 mm [0.010-inch] beyond the pan flange.

Crankshaft Seal, Rear - Installation

Use the installation sleeve provided with the seal to install

the seal on the crankshaft.

NOTE: ‘‘LDL TFE’’ (Lay-down Lip, Teflon) oil seals for ser-

vice replacement have an assembly tool which protects the

seal lip during shipment and installation. The ‘‘LDL TFE’’ oil

seal must be installed with the lip of the seal and the crank-

shaft clean and dry. Do not use any kind of lubricant. The

use of lubricant will result in oil leakage at the seal.

Push the oil seal over the installation sleeve onto the

crankshaft, and remove the sleeve.

Crankshaft Seal, Rear - Installation Engine Assembly (00-02)

N14Page 0-66

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 86

Kommentare zu diesen Handbüchern