CUMMINS N14 Spezifikationen PDF herunterladen (Seite 95)

100

101

Install the flywheel, and inspect the bore runout again.

Replace the flywheel if the runout does not meet

specifications.

Face Alignment - Measurement

Install the contact tip of the indicator against the flywheel

face, as close to the outside diameter as possible, to

inspect the face (4) runout.

Push the flywheel forward to remove the crankshaft end

clearance. Adjust the dial on the indicator until the needle

points to ‘‘0.’’

Rotate the crankshaft one complete revolution. Measure

the flywheel runout at four equal points on the flywheel.

NOTE: The flywheel must be pushed toward the front of the

engine to remove the crankshaft end clearance each time

a point is measured.

Engine Assembly (00-02) Flywheel - Installation

N14 Page 0-75

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 586 587

Kommentare zu diesen Handbüchern

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Spezifikationen Seite 95

Kommentare zu diesen Handbüchern